I have a problem with an hd1010 device. It hasn't been used in production yet and has only been configured on my desk. I noticed the other day the red error light was flashing and I couldn't get anything to display on the monitor, it turns the monitor on like its getting a signal, but doesn't do anything and it eventually goes to sleep. I tried to reset using the reset button and it didn't help. I then tried to update the firmware using the one downloaded from the website and I no longer get the error light, but its still not working. I am connected to the device over serial and it appears to just be rebooting. there is a lot of additional chatter, but this little bit is what I am seeing over and over
Requesting system reboot [ 68.420000] Restarting system. [ 68.424000] [ 68.424000] [ 68.424000] Restarting ... ### send_event ### Recovery script suggests next URL of http://services.brightsignnetwork.com//recovery/recovery_runsetup_ba.brs ### Looking for file from http://services.brightsignnetwork.com//recovery/recovery_runsetup_ba.brs ### xfer to CF success = -2 ### xfer to SD success = -2 ### xfer to USB1 success = -2 The system is going down NOW! I do have the network connected and it should be able to get out. What do I need to do now? as its currently just a dead unit.
